WEHA Blue Miter Clamps – Set Of 2
$804
In stock
Weha Miter Clamps for Granite, Marble, Engineered Stone, Ceramic, Porcelain counter tops Set Of 2
The Weha Miter Clamp is the perfect solution for doing miter lamination’s either in the shop or on the job site. The Weha Granite Miter Clamps vacuum to
the top of the stone using a suction cup. The Weha Miter Clamps hold the stone at a 90 degree angle for a perfectly tight 45 degree miter joint. Simply
vacuum the Weha Miter clamp to the stone for a solid grip. On brushed and honed surfaces the vacuum is not required. The vacuum cup will rest on the
stone and still hold firmly without slipping. Use the slide lever to get the rest arm in close proximity to your apron width. Place the Apron on the
arm. Apply adhesive to the the stone. With threaded adjustments up and down as well as in and out, micro adjust the joint to make a perfectly tight
fit. Miter pieces are installed finished side up and out so that you can see the seam and work with the glue for a finished piece. The Weha Miter Clamp
automatically squares the miter. No more tape or blocks to finish the pieces. Holds the piece 100% solid with no movement until the glue cures. Once
the apron edge is on the arm, the piece will rest while adhesive is applied. Drastically increases lamination install time.
Maximum Laminated Edge: 9″
The Weha Miter Clamps work perfect with Dekton, Lapitec, Neolith, Maximum , Laminam, Florim and all engineered stones.